For Prices and Inquiries call 1-800-345-4400

Electrical Packages

Both standard and poly-core A-WALL panels are shipped with the electrical device boxes and conduits with pull-lines factory installed, for ease of wiring on-site. You specify the electrical devices you require and designate their locations. The standard electrical package includes a main breaker panel, 2’ x 4’ recessed, fluorescent light fixtures, switches, receptacles and additional device boxes with pull lines for your low voltage devices.

Electrical Devices

Unlike most modular building systems that limit wiring and device locations to narrow, hollow posts at their panel connections, standard A-WALL panels are equipped with three independent wiring cavities. This allows you to specify switches and receptacles, as well as phone and data boxes… All in the same panel. If additional devices are required after the modular office is installed, these cavities facilitate concealed wiring using common, “off-the-shelf” device boxes and conduit.

outletLight Switch
outletDuplex Receptacle
outletPhone and Data Boxes
outlet2-Gang Light Switch
outletQuad Receptacle
outletLow Voltage Boxes

Panel Wiring Options

Two “factory wired” options are available to significantly reduce installation time. The Factory Pre-Wire package eliminates field wiring of the receptacles and switches. These devices are factory wired in flexible conduit, with pigtails and box connectors terminating at the top of the wall panels. The FLEX-4 Modular Wiring package offers even greater speed of assembly and future flexibility.

a-wall factory pre-wire package

Factory Pre-Wire

Switches and outlets are factory wired in the panels using U.L. listed devices. They are flush mounted in the panels just like in permanent construction. An electrician wires the pigtails and light fixtures to the breaker panel using the ceiling plenum, and provides power to the building.


a-wall FLEX-4 modular wiring package

FLEX-4 Modular Wiring

Switches and outlets are factory wired in the panels using U.L. listed, Flex-4 connector cables. The light fixtures are also prepared for the Flex-4 so all the electrical components "snap together". An electrician is only need to wire the breaker panel and provide power to the building.


Featured Application:

CMM Rooms

Learn More...

Green Alternative!


Recycle Logo

A-WALL Modular Construction is 100% Reuseable! Learn More...

Why A-WALL?


Question Mark

Compare A-WALL Building Systems to Alternative Construction Methods.

Call 1-800-345-4400 to speak with a representative